Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Dallas Owner’s Guide
Boral fence installation in Dallas typically runs $3,500 – $9,000 for a full panel replacement job, depending on section count, gate hardware, and whether existing concrete posts can be reused. We stock Boral-compatible fence boards and rail components on our trucks and can usually match your existing profile the same day we inspect it. Most Dallas homeowners discover the issue the hard way: a panel bows after a spring storm, a post shows hairline cracks along the concrete base, or a fence section lists toward the alley like it’s given up. The good news is Boral fencing uses a closed-cell polymer composite, which means the failure is almost always a single component, not the whole fence line.
One thing worth naming up front: Penhallow Remodeling Dallas is an independent service provider, not a Boral-authorized dealer or affiliated with Boral. We install and repair Boral-style composite fencing because Dallas homeowners keep asking for a fence that doesn’t rot, warp, or feed termites. That’s a standard we’re glad to stand behind.
Which Boral Models This Applies To
Boral’s fence product line is a closed-cell polymer composite built to mimic clear cedar. The two profiles we see most in Dallas are the Southern Pine and Clear Cedar texture boards, both milled at 5/8-inch thickness and sold in 6-foot and 8-foot lengths. If your fence predates Boral’s 2019 rebranding, you may be sitting on the older NexGEN series, which uses the same tongue-and-groove profile but a slightly lighter gray base color. This matters more than you’d think: new Boral boards paired against aged NexGEN boards will read as a two-tone repair unless you’re replacing the whole panel run.
The compatibility gotcha in Dallas is heat. Boral boards expand measurably across a 40-degree Texas afternoon. Walls that were installed tight in January will start binding at the tongue-and-groove seams by July. We leave a 1/8-inch gap at every third joist on south-facing runs, which is a spec detail a lot of fence crews skip. If your boards are popping or puckering along the top rail, the fence wasn’t installed with a Texas expansion allowance. For replacement boards, we recommend Boral factory product over aftermarket knockoffs. The real stuff carries the density and color through the entire board; cheaper substitutes can delaminate within two summers here. Given salt, hail, and UV, it’s the original product, not a lookalike, that lasts.
Styles & brands we work with
Signs Your Boral Fence Installation Is Failing
Boral boards are tough, but the surrounding structure isn’t. Here’s what we pull apart when a Dallas homeowner calls about a failing Boral fence:
- Boards popping loose at the bottom rail. This is usually not the board. It’s the rail behind it. A pine rail in Dallas soil rots at the fastener line inside of four years, and the Boral board just lets go with it. The composite outlasts the frame almost every time.
- Post lean at the gate corner. A fence is only as straight as its posts. Gate posts carry double the load, and if they were set in less than 2 feet of concrete and a good 6-inch footing, they’ll start to walk. We see it most in North Dallas clay, which shifts with every wet-dry cycle.
- Seam gaps opening up in winter, tight in summer. That’s normal thermal movement, but if gaps exceed 3/8-inch in January, the original installation didn’t pack the bottom channel with enough room to rise. Your fence isn’t failing – it was set up wrong from day one.
- Gray, chalky surface after three years. Boral fades like any pigmented product under Texas sun. It’s cosmetic, not structural. But if the color is patchy across panels, you’re seeing board replacements from different production lots, which means someone’s patched before.
- Sagging between posts. Rails, not boards, carry the span. If your panels bow in the middle, the rails are undersized for the post spacing, which increases the load and eventually snaps the board channels. You’ll hear it coming before you see it, usually a percussive rattle in high wind.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Boral fence installation in Dallas carries a realized installed range of $3,500 – $9,000. A partial repair – say, a single failed post and one replacement panel – commonly runs $800 – $1,600. What drives the spread on a full job is the length of run, the number of gates, and what’s happening under the surface. If we can pull old boards, sister in new rails, and reuse the posts, you’re on the low end of that number. If the posts are shot, the whole fence is coming out, and that’s real labor: concrete demo, new footings, and a day of setting before we even start hanging boards.
What you won’t get on the invoice is a surprise line for disposal, fuel, or “premium hardware.” Our written estimate covers the full job. When I walk a fence in Dallas, I take measurements, name the board profile, and price it before we schedule. On top of the Boral material warranty, we cover our work for 365 days through the Done Right Promise. If a board pops or a gate binds inside that window, we come back and fix it. No service call, no re-inspection fee. It’s in writing.
DIY or Call Us?
Some of this work is genuinely safe to inspect yourself. You can walk the fence line, run your hand along the bottom rail for soft spots, and rock each post to feel for movement. That’s honest homeowner detective work, and it tells you a lot. What you should not attempt is pulling a Boral board off a tensioned rail. Boral’s tongue-and-groove interlocks under load, and when that load releases, the board edge can split fast and catch a hand. The same goes for pulling posts in Dallas clay with a come-along. That’s a two-person job with the right prying bar, and it’s the top way we see homeowners hurt themselves on fence repair. If the board is cracked, the rail is rotted, or the post is moving, call us. It’s safer, and it’s usually cheaper than the emergency room visit. Call (940) 204-5368 and we’ll put eyes on it.
FAQs
Boral’s closed-cell polymer is rated for 50-plus years on the board itself. The structure around it – wood rails and concrete posts – is what fails first here, usually between 15 and 25 years in Dallas soil depending on drainage. If your rails are pressure-treated and your posts are set with proper drainage gravel, the fence outlives most mortgages. If they used untreated pine in clay, you’re looking at a rail failure inside a decade.
A hairline crack near the base of a concrete post can sometimes be stabilized with an epoxy fill and a galvanized post strap, but only if the post is still plumb. Once the crack opens more than 1/8-inch or the post leans past half a bubble, it’s done. In Dallas, the wet-dry cycle turns a small crack into a split within one summer, and a split post cannot carry a gate hinge. The only honest fix is a new post set below the frost line with a proper footing. Call (940) 204-5368 for an exact answer on your post – estimates are free.
A single post replacement runs about half a day, including the concrete cure time for the footing. A full panel run, even with new posts, is two to three days. The slow part isn’t the Boral boards – it’s setting posts and letting concrete cure before we hang anything. We schedule the work so your fence is never down overnight without a temporary panel in place.
We keep the common Boral profiles on the truck: 5/8-inch Clear Cedar and Southern Pine texture in both 6-foot and 8-foot lengths, along with the matching rails and post sleeves. If your fence is an older NexGEN profile or a custom color, we order factory-direct from the supplier we source through, usually a seven-day lead. We also stock parts for KraftMaid, Cambria, and Silestone, so if a kitchen project is next on the list, there’s no second call to make.
Ready to get your Boral fence back to straight? Call Penhallow Remodeling Dallas at (940) 204-5368. We’ll walk the fence line, hand you a written price before any work starts, and stand behind the installation for a full year. That’s the Kingswell Way – and it applies to every post, every board, and every gate we hang in Dallas.
Written by Trevor Nash, Owner, Penhallow Remodeling Dallas at Penhallow Remodeling Dallas, serving Dallas and nearby areas.
